Inspected the unit and found everything functioning as it should from factory upon arrival notified customer to always go clockwise with the timer as it will hang up if you dont. All checks OK

Installed parts. Ran a test cycle. All checks OK

Went to install main control and found that it was defective. Re-ordering control.; ordrng 1 WH22X38441 (Main control)

Inspected the unit and found that I could not verify the unit due to the tag not being legible. But went ahead and ran it through diagnostics. Found multiple codes for an off balance load. Suspension checked OK. I found that it was in need of a firmware update. Updated firmware. Ran a test cycle. All checks OK

Inspected unit and found that a wire had come off of the element in the back of the unit. Cut off a burned and and added a new paddle reconnected and tested dryer. Dryer is now heating the way it should. Im also ordering a new timer knob because this one is broken. ; ordrng 1 WE01X24552(Customerwillinstall) (Dryer knob)