Installed parts and reset to manufacture setting

Installed parts listed, all checked good

Check out the unit and found the unit spinning out of balance. Recalibrated the tub and ran a diagnostic cycle and the unit completely with no issues. The basket is starting to become hard to turn due to possible bearings in the tub going out. Unit is in pretty rough shape and it is approximately 10+ years old. Checks OK

Checked unit over found that the washer was leaking due to the drain screen being unscrewed. Tightened down and tested checks ok

Unit needs control board and fan assembly not communicating properly ordered parts to be installed ; ordrng 1 AEB76044922 (Fz fan assy) and 1 EBR88309755 (Control brd)